1 шт. GPS модуль NEO-7N вместо NEO-6M ublox спутниковый позиционер навигации для Arduino/STM32/51

1)There is micro usb,can be adjust the module by android usb

2)Set aside TTL interface, easy to use USB-TTL or external microcontroller control to receive GPS information

3)NEO-7N core is recommended for the NEO-7N core, because NEO-6M official has been discontinued, the replacement part number is NEO-7N, the price advantage, and NEO-6M use no difference are NMEA standard protocol output , Built-in FLASH, without external EEPROM can save settings information power-down.

4)SMA no welding,Can be used directly onboard antenna, do not use external antenna

5)With SMA head, SMA head is not welded, need to self-welding, if weld by yourself that need access the external antenna, please note that if you use an external antenna, you need to remove the C2 capacitor on the board to prevent the use of built-in external antenna caused by the impact of conflict positioning.

6)if you weld the SMA ,you need to buy an external antenna to use, if no use the external antenna the module can not be used

7)Module onboard antenna is a ceramic antenna, open place without external antenna can be convenient to give stars

GPS module can only use the outside, the room can not be positioned, because there is no satellite signal,

If you use an external antenna can put the antenna outdoors, easy to debug!

1 Vcc 3.3-5V

2 GND Ground

3 TXD Module serial port to send Pin (TTL level, can not be directly connected to RS232 level) can be connected to the microcontroller RXD

4 RXD Module serial port to recieve Pin (TTL level, can not be directly connected to RS232 level) can be connected to the microcontroller RXD

5 PPS Clock output Pin

Working voltage 3.3v-5.0v

Current: 40mA

Default baud rate: 9600 (can be modified by U-CENTER)

Output frequency: 1Hz (can be modified by U-CENTER)

1*GPS Module